Bacharach Model 100 Specifications download pdf (Page 32)

Instruction 0024-9395

Fyrite Pro

4.8 Printing Test Data

Tip: To avoid printing errors, it is important to select the

correct protocol per Section 3.5.8 before saving data.

Turn ON the printer. Refer to the printer’s instruction manual for detailed

operation and maintenance information.

If not already done, set the printer parameters as follows:

• Data: 8 bits • Parity: None

• Baud: 9600 • Handshaking: X-on/X-off

Align the printer with the top of the analyzer as shown in Figure 4-1.

The next step in the printing procedure depends on the model of the ana-

lyzer, and whether the operator desires to print only the current test data,

or all stored test data starting with the most recent. Perform the appropri-

ate procedure below:

Model 100 – Print Current Test Data

With the analyzer in its Run Mode, begin printing by pressing the HOLD

button twice.

Model 105/110/120/125 – Print Current Test Data

1. With the analyzer in its Run Mode, press the HOLD button twice to

display the Print Screen.

2. Press ENTER to start printing.

Model 105/110/120/125 – Print All Test Data

1. With the analyzer in its Run Mode, press the HOLD button twice

to display the Print Screen. Then press the ▲ button to display the

Print All Screen.

2. Press ENTER to start printing.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 63 64

No comments

Bacharach Model 100 Specifications Page 32