Bacharach Model 100 Specifications download pdf (Page 11)

Instruction 0024-9395

Fyrite Pro

3.0 SETTING UP THE ANALYZER

3.1 Preliminary Steps

Before using the analyzer . . .

• Check batteries (Section 3.2)

• Connect probe to analyzer (Section 3.3)

• Check setup (Section 3.5)

3.2 Checking & Replacing the Bat ter ies

Install fresh batteries as described below. Check the analyzer for sufficient

charge prior to each use. Replace the batteries if the low-battery symbol

appears in the lower right corner of the screen. To re place the bat-

ter ies:

1. Remove battery cover from back of analyzer.

2. If old batteries are installed, remove them and properly discard.

3. Observing the polarity markings inside the battery com part ment,

install four ‘AA’ Al ka line bat ter ies as shown in Fig ure 3-1.

4. Replace battery cover.

Figure 3-1. Battery Installation

Remove battery cover by

pushing down on cover

and sliding it outward

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 63 64

No comments

Bacharach Model 100 Specifications Page 11