Bacharach HGM-SZ Specifications download pdf (Page 6)

2 Instruction 3015-4256

Safety Precautions

AC Power Supply

The HGMSZ uses a universal power supply that is capable of accepting inputs of 100 to 240 VAC,

50/60 Hz. The monitor’s power consumption is 15 Watts. It is highly suggested that the monitor be

connected directly to the AC power source, preferably on its own circuit (with UPS or surge protection).

A switch or circuit breaker rated 1.0 A, 250 VAC, with a minimum terminal spacing of 3.0 mm must be

attached to the monitor’s AC power leads. This switch must also be located in close proximity to the

monitor, and be in easy reach of the operator. This switch should also be clearly marked as the monitor’s

main AC disconnect device.

Protective Grounding

Under no circumstances should the HGMSZ be operated without connection to a protective ground. Doing

so poses a potential shock hazard and is also a violation of electrical safety standards applicable to this

type of equipment.

Explosive Atmosphere

Do not operate this equipment in the presence of flammable liquids, vapors or aerosols. Operation of any

electrical equipment in such an environment constitutes a safety hazard.

Proper Exhaust Venting

It is imperative that the monitor’s exhaust port be vented as described in this manual. Failure to do so

may constitute a safety hazard.

Working Inside Monitor

Extreme care should be exercised when accessing the interior of the monitor. Only qualified electrical

maintenance personnel should perform connections and adjustments. Always remove AC power before

working inside the monitor.

Misuse and Modifications to Monitor

The protection provided by the monitor may be impaired if the monitor is used in a manner not specified by

Bacharach, Inc. Changes or modifications to this monitor, not expressly approved, will void the warranty.

In Case of Malfunction

Do not continue to use this equipment if there are any symptoms of malfunction or failure. In the case of

such occurrence, de-energize the power supply and contact a qualified repair technician or the nearest

Bacharach Service Center. Use ONLY the provided knockouts for electrical and communication wiring.

Drilling into the box will void the warranty.

Fusing

F1, F2: 1.0 A, 250 V, Type “F”

Installation Category

Installation Category II, Pollution Degree II, as defined by UL.

Altitude Limit

6,562 ft (2,000 m)

Cleaning

To clean the outside of the case, DO NOT use soap and water. USE a dry cloth.

1 2 3 4 5 6 7 8 9 10 11 ... 33 34

No comments

Bacharach HGM-SZ Specifications Page 6